Wiegand RFID Conversion Cable with UART Serial OutputThis accessory converts the output of a Wiegand RFID reader, and sends the ID to a UART TTL Serial output. In addition, the cable will also provide the following features: Convert input voltage from 10 30VDC down to the proper DC level to power the RFID reader Provides a enable line to control power to the reader Floating or Ground = Off 3. 3VDC = On Note: Another variant of the cable is available to remove this functionality HTD 009 B1 Passes through

The table below shows the six connections that are mapped from the j1939 to OBDII

Power Enable

Wiegand RFID Reader compatible with HID 125kHz Cards

3-5 VDC 1 wire bus Temperature and Humidity sensor

and sends the ID to a 1-Wire interface utilizing iButton protocol

Side 2 - To Next Sensor

Black = Ground

Cable provides three OBDII connectors that allow a device to be connected to the vehicle

9-pin J1939 Type I connector 'Y' cable to 15-pin HDSUB connector for CalAmp jPOD devices

and sends the ID via RS232 Serial output

in length to give a total length of 2ft

formerly Heitech Part CC-057