Road vehicles. Environmental conditions and testing for electrical and electronic equipment for drive system of electric propulsion vehicles - Chemical loads1 Scope This document specifies requirements for the electric propulsion systems and components with maximum working voltages according to voltage class B. It does not apply to high voltage battery packs (e. g. for traction) and systems and components inside. It describes the potential environmental stresses and specifies tests and requirements recommended for different stress levels on in the vehicle. This document describes chemical loads. NOTE

BS 6972 on requirements for luminaire supporting couplers is helpful for:

the employed technologies supporting this International Standard may enable additional non-standard security measures to be added for specific applications

InternetGatewayDevice:2 encapsulates several sub-devices and services that collectively comprise the Internet Gateway Device Control Protocol (DCP)

methods of test (IEC 1067-2)

it will be necessary in every case to carry out incremental sampling of the whole quantity

by using BS 7141-2

Ergonomical hazards

assisting users in implementing the necessities for agricultural waste management

This Recommendation | International Standard covers the concepts which are needed to perform the modelling of ODP systems (see clauses 6 to 14)

Analysis of the supply chain 11

The calculation methods have been developed for the calculation of the basic energy loads and needs

for single-start