BS ISO 3548-2. Plain bearings. Thin-walled half bearings with or without flange. Plain bearings. Thin-walled half bearings with or without flange. Part 2. Measurement of wall thickness and flange thickness

The project managers

this assists in the production of light duty braided rubber cord of high quality and durability

PD IEC/TR 62131-2 primarily addresses data extracted from a number of different sources for which reasonable confidence exists as to their quality and validity

Automatic watermist nozzles operate at a pre-determined temperature to discharge water over a known area below

Hydraulic control systems

BS EN 16620 specifies a method for the determination of furan in coffee and coffee products with headspace-gas chromatography-mass spectrometry (HS-GC-MS)

This Technical Specification specifies a method for the determination of the Fracture Toughness temperature

The seismic qualification must assure the equipment will hold its capability to perform the required safety functions during and after a seismic event keeping such a state that corresponds to the end of its qualified life

Inclusion of carbon monoxide alarms

Other requirements and other EU Directives may apply to the devices within the scope of BS EN 50615

allow user control of display characteristics such as brightness and contrast

The test method helps in calculating and estimating the lifetime