JXB Driveshaft Center Support Bearing Carrier Upgrade - Audi / Mk2 TT / TTS / TTRSHolds the driveshaft where it should be. Isolation dampers minimize vibrations. The ProblemThe stock center support bearing carrier holds the driveshaft in place with rubber so thin about 20 lbs. of force moves it from center to the end of its travel. While thats great for making sure no NVH makes it to the cabin, the stock bushing is extremely prone to failure, especially in harsher climates and on higher powered cars. Even on the best kept cars, the

KICKDOWN REMOVED IN TIPTRONIC/MANUAL MODEThe kickdown switch is disabled in manual shift mode

The Options

dyno testing and design optimisation

Smooth transitions between the aluminum tubing and the silicone hoses decrease turbulence and minimize pressure loss

75 inch 146 mmLoad at Block Height: 834 lbs 3710 NWeight: 2

using the stock plumming

for the earlier models with a diameter of 80mm use PFR5-1105

079109469AD (late)

it could not be removed

Oil coats the intercooler

- Intake Manifold Gasket (Victor Reinz)

6061 Aluminium Anodized Bell x2