Morse taper adaptor BT 40 - 2 - 50Application: For clamping tools with Morse taper shank and thread according to DIN 228 1 form A. Delivery: With built in tightening bolt All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m Tensile strength in the core of min. 800 N mm after DIN All functional surfaces fine machined

For adaption from ISO40 to PSC (ISO 7388-1 to ISO 26623-1)

Hardening depth 0

Hardened and grinded all around

Delivery: without inserts

Improves chip evacuation and decreases the risk for chip jamming

Clamping force preadjustable by graduation lines

Calibration of the angular position of spindles of milling-turning centres

nuts and plain washers

The tool inserts are made of oil-resistant

Contact surface precision grinded

- Calibration of the angular position of spindles of milling-turning centres

Coolant pressure up to 100 bar