Robinson Racing Extra Hard Steel .8 Mod Pinion Gear w/5mm Bore (15T)Overview Extra hard high carbon brushless motor pinions are built to last with hi performance GEN3 steel slipper units. Pinion is precision machined and stamped with the number of teeth. One 4mm set screw included. 2mm allen wrench (not included) fits the 4mm set screw. Can be run on cars using a 5mm motor shaft. 5mm to 1 8 inch Reducer Sleeve required for 1 8 inch shaft motors. Note: 32 pitch and . 8 module gears can be used together with no adverse

Maximum Charge Rate: 1A / 2A / 3A / 6A User Selectable

The compact Recoil 2 18” fits easily into your car to take wherever a suitably sized body of water waits

This allows Power Cell LiPo's to offer greater capacity in a given size

Now Waterproof

with molded lenses on all four corners of the body

Any internal/non visible damage or malfunction will be evaluated and determined by R1wurks staff

Each component

4V/750mAh)

FAN Control

5mm thick polycarbonate and allow for an extremely aggressive look

simply change profiles to unleash full-throttle action

The difference is that