Shrink chuck 4,5° with cooling channels HSK 63 - 18 - 120Application: For mounting tools with straight shanks. Note: Toolholders suitable for induction , contact and hot air shrink units. 3, 4, 5 with h4 tolerance and 6 32 with h6 tolerance For 3, 4 and 5 mm only solid carbide tool shanks must be used! All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m

Retaining screw for mounting of face mills arbors

Toolholders suitable for induction-

Improves chip evacuation and decreases the risk for chip jamming

without a tool

For d = 60 only with four fi xation screws according to DIN 912

Kontakt- und Heißluftschrumpfgeräte geeignet

driving ring and feather key

without cooling lubricant supply

- Longer-lived than standard collets

5 with h4-tolerance and Ø 6 – Ø 32 with h6-tolerance4

chip breaking

Dragged-in prism