Webasto Surface Mounting Kit - No HardwarePlease note this is the sleeve only with no hardware if you need the kit with hardware please click here. Youll want to use this part when installing a Webasto heater when there is already a subfloor (such as plywood) in your van such that you cannot install the heater directly onto the vans factory metal floor. Its basically a metal sleeve that fits into the 4 hole you cut through the floor during your standard installation. Then you seal the sides

It works great between bench seats

Supports Victron communication

5″ tall x 10

Webasto: 5013751A

Approximate Installed Weight: 42

No drilling is required

Can I connect it to a solar system

Add a flush mount flange for the installation of a Dometic NRX-130C

DIY-friendly installation – bolts directly to factory rear door hinges with a re-engineered bracket system and built-in safety straps

Product Manual

Shipping Weight: 5 lbs

These recommendations are in ranges from minimum to maximum