Solid biofuels. Bridging behaviour of bulk biofuels1 Scope This document summarizes current knowledge concerning a test method and its technical implementation, and existing knowledge about the bridging performance of biofuels. The document consists of three parts, as follows: Part I: Method for direct determination of bridging behaviour, to make it available for research and development purposes (see Clause 4). Part II: Implementing the measurement principle, to assist in the construction of test

the density is necessary to allow specified values of the magnetic polarization

Specific ergonomics requirements for visual display terminals (VDTs) used for office tasks are given in the standard EN ISO 9241

This International Standard specifies a method for the determination of the size distribution of particles of vinyl chloride homopolymer and copolymer resins by measuring the amounts retained on a selection of sieves having meshes of various aperture sizes

For elementary relays with reed switches

along with the reference standard for guidance on materials along with surface treatment for self-locking hexagonal nuts

Automatic watermist nozzles operate at a pre-determined temperature to discharge water over a known area below

5 mm2 total cross-section because the conductor melts before the test is completed

and/or to determine a limiting flaw size for a component subject to a given operating environment and to determine the time to reach the limiting state

BS EN 756:2004 replaces BS EN 756:1996 which is withdrawn

which includes air entering mechanical ventilation systems in domestic residential

to anodic oxidation coatings above 10 μm

ISO 8626 establishes: