Shrink chuck 3° HSK 63 - 05 - 160Application: For mounting tools with straight shanks. Note: Toolholders suitable for induction , contact and hot air shrink units. 3, 4, 5 with h4 tolerance and 6 32 with h6 tolerance For 3, 4 and 5 mm only solid carbide tool shanks must be used! All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m

5 with h4-tolerance and Ø 6 – Ø 32 with h6-tolerance1

wrench and collets

For the manufacturing of special tools

All tool sizes can be combined

Collets sealed for high pressure cooling 120 bar

With balanced clamping nut All holders are made of forged steel

For face machining

The insert is clicked into our grid system with

With ball bearing clamping nut

In NC machines (machines without automatic tool changers)

LSCX = Clamping depth

which can cause high frictional forces on the thread flanks