Malibu Boats Strut Complete with Bushings 1 inch shaftNew Malibu Boats Complete strut with Bushings for a 1 inch shaft. This strut was commonly used on Malibu's built in the 1980s. There was some variation to parts used to build boats back then so make sure to verify yours to the photos. Malibu's parts description shows this strut was used on Malibu Skier and Malibu Sunsetter boats built 1984 1989. No hardware is included, do not forget you need a marine adhesive sealant for below the waterline when

Replacement Knock Sensor

and protects all fiberglass gel coat marine or RV surfaces in one easy step

OEM Replacement: Direct factory replacement for Malibu Power Wedge actuators

Replaces Crusader R077019

There's a lot of power packed into this one product

this quick release Bimini hinge allows you to easily remove or install your Bimini top without keeping track of loose screws or pins

The LT 1 uses two thermostats

To shine and protect newly cleaned hull

11" x 16" x 7" durable

The Viper2 Command Screen allows you to easily control your Malibu boat

Outside diameter 1-3/8 Inch

080" Inches