Open end blind rivets with break pull mandrel and protruding head. A2/A2

BS EN 1997-2 sets out the rules for the planning and reporting of ground investigations

BS 8103-1 is the first part of the multi-series that outlines best practices for ensuring the structure's safety and soundness

An appropriate thread sealant or jointing compound should be used on the thread to ensure pressure-tight joints

BS EN 17116-2 helps you to manufacture low energy consumption batch drying tumblers and reduce energy demand

ceramic shot

suspended by jacks

and the characteristics of halon 1301 and the types of fire for which it is a suitable extinguishing medium

BS EN 60300-3-2 can be applied during monitoring of a population sample or

Instructions for use and maintenance

This document provides requirements for design and guidance on the selection (based on a risk assessment) of THCDs including the prevention of defeat

This Part of BS 5482 provides guidance and recommendations for the installation of liquefied petroleum gas (LPG) supply systems at permanent dwellings

25 mm) supplied in the full width of approximately 36 inches (915 mm) or slit into tape