Plastics pipes and fittings. Decohesion test of electrofusion assemblies. Strip-bend test1 Scope This International Standard specifies a strip bend test method for the evaluation of ductility of the fusion joint interface of assemblies of pipe and electrofusion fittings and saddle fittings intended for the conveyance of fluids. It is applicable to polyolefin assemblies. NOTE The aim of the strip bend test method is to provide a quick check in order to have an indication of the ductility of the electrofusion interface.

It specifies the transformation rules from level 3 to level 4

BS EN 61300-2-21 describes a test that covers the effect of the freezing of trapped water in cracks and fissures as well as condensation

Mapping of the common data classes (CDC)

ISO/TS 22773 aims to specify categorical structures in the field of decoction

A procedure for estimating weighing uncertainty is described

roofs and partitions

BS IEC 63068‑2 on semiconductor devices is useful for:

This part of ISO 25964 is not applicable to the preparation of back-of-the-book indexes

b) the procedures for conducting the measurements

This International Standard provides identification coding for manifolds used in hydraulic systems and for component installation features (for example

BS EN 12896-4 helps in improving operations monitoring and control in public transport

BS EN 50083-9 covers all kinds of networks like CATV-networks