Implants for surgery. Partial and total hip joint prostheses - Classification and designation of dimensions1 Scope This part of ISO 7206 provides a means of classification and standardizes the designation of dimensions for partial and total hip joint prostheses.

for use in general engineering applications

the resistance to ponding water or to hydraulic pressure absorbed by a limited part of the surface

Outlet of receiving systems

Testing laboratories/test personnel

Lighter users

giving verification procedures for metrological characteristics and in-service verification to ensure that the system meets the in-service inspection accuracy class

Geosynthetic clay liners

you can identify the failures in these MEMS systems

This document specifies the requirements and corresponding test methods for moulding materials in powder form made from ultra-high-molecular-weight polyethylene (UHMWPE) for use in the manufacture of surgical implants

you can check the tolerances of hot-rolled aluminum sheets which gives you proper fit and designs for aluminum alloys products

to the point where it is discharged into a treatment works or receiving water

maintenance and installation of electrical lifts