Rack mount for Apple Time Capsule 4th Gen (Modular)3D Printed rack mount that lets you mount your Apple Time Capsule 4th Generation (Late 2011) into a Single RU in a standard 19 Inch Rack! This is part of our ModMount Range, so you can mix and match your parts! This item is Omni directional, so you can use it on the left or right side. NOTE: You will need to pair this with another ModMount item (Like a Blanking Plate) to make a full 1RU Width, screws are included to join the parts. The Time Capsule

3D Printed 3RU rack mount for 3x 120mm Fans

The Firewalla slides into the frame from the front

Now available in a version to suit Unifi Toolless Mini Racks

so make sure your screws are deep enough

Supported Models:

The device slides into the mount from the front and cables are accessible from the rear

02 POE Injector

simply remove the rear bracket and slide your device into place then screw the Rear Bracket back in

3D Printed 2RU rack mount for the Netgear MS108EUP 8 Port Multi-Gigabit Ultra60 PoE++ Switch

The Switch slides into the frame from the back and then is secured in place with the Retaining Plate

The Cable modem slides into the frame by removing the backplate

3D Printed 1RU rack mount for the Firewalla Purple / Purple SE