Implants for osteosynthesis. Skeletal pins and wires - Specification for dimensions of Steinmann skeletal pins1 Scope This part of ISO 5838 specifies the dimensions of Steinmann skeletal pins. Material and mechanical requirements are covered by ISO 5838 1. NOTE 1 Attention is drawn to the possible need for different designs of points depending on such factors as the method of insertion, and the site of insertion, i. e. whether the bone is cancellous or cortical.

BS 4656-2 is the second part of the BS 4656 multi-series that discusses the accuracy of machine tools and methods of test

Figure 12 – Joints in an air barrier formed by a plasterboard-lined timber frame wall using plasterboard tape

Construction building

• Hoppers

This part of BS EN ISO 22442 can only be used in combination with BS EN ISO 14971 and is not a “stand-alone” Standard

motor vehicles workshops and computer areas

the risk assessment and determination of suitable protective measures is the responsibility of the manufacturer of the machine

What is BS 4998 – Specification for moulded thermoplastics dustbins about

Figure 1 — Examples of location of test specimens — longitudinal plane section 3

74 mm outside cable diameter

BS EN 16842-6 is one of a series of documents applicable to test the visibility of industrial trucks

NOTE: BS EN 50318 does not apply to trolley bus systems