54350 Type 130-MRO Maintenance Length 1/2" Reduced Shank 135Â degree Split Point 3-Flats on Shank Surface Treated Drill BitThe 130 MRO is a shorter (5") tougher version of our very popular 1 2" reduced shank product. Designed specifically for the needs of the MRO market, the 130 MRO has a 135? split point to insure fast hole starts without drill walking. The three flats on the shank insure positive chucking with out slippage. Click Here for product catalog Proudly Manufactured in the U. S. A

Titanium nitride coating provides a super hard surface with high lubricity

Fitting Installation or repair consists of cutting the hose square

Click here for spec sheet: NAT Spec Sheet

• Manufactured to NAS 907 B aerospace specification

the number of products that complement this series of gear drives make it an ideal choice for today’s industrial distributor

non-intersecting shafts

It is important to note that this tool is designed to balance the tool where the operator places it

Reads in PSI and kPA

when installed between the tool and the supply line

but will still ignite if exposed to flames

Seats are silicon rubber to provide a long leak free service life

rather than continual trips back to the job-site's compressor