Slotted raised countersunk (oval) head tapping screws1 Scope This International Standard specifies the characteristics of slotted raised countersunk (oval) head tapping screws with thread sizes from ST 2,2 to ST 9,5 inclusive.

other than liquefied petroleum gases (LPGs)

to the test gas

It does not apply to suburban vehicles

as supplied or as prepared in the laboratory by dilution of concentrates

This Technical Specification specifies the general rules for labelling and marking of containers for essential oils to enable the identification of the contents

to preserve natural resources

Sources and magnitudes of uncertainties arising in the certification process are detailed in Annex E

typically 21 % v/v

BS IEC 62396-3 provides guidance and furthermore it provides necessary requirements for those involved in the design of avionic systems and equipment and the resultant effects of atmospheric radiation-induced single event effects (SEE) on those avionic systems

Signal state

BS EN 60862-2 gives practical guidance on the use of SAW filters which are used in telecommunications

– surge arresters