Methods for the calibration of vibration and shock transducers - Primary vibration calibration by the reciprocity method1 Scope This part of ISO 16063 specifies the instrumentation and procedures to be used for primary calibration of accelerometers using the reciprocity method and the SI system of units. It is applicable to the calibration of rectilinear accelerometers over a frequency range of 40 Hz to 5 kHz and a frequency dependent amplitude range of 10 m s2 to 100 m s2 and is based on the use of the coil of an electrodynamic vibrator as the reciprocal transducer.

BS EN 590:2009 supersedes BS EN 590:2004

ISO 10651 consists of the following parts

BS EN 764-2 is the European Standard which specifies the basic quantities

ISO 7971 discusses the bulk density of cereals

ISO 5834-4 applies to ultra-high molecular weight polyethylene (UHMWPE) intended for use in surgical implants

High-strength structural bolting assemblies for preloading - Part 3: System HR - Hexagon bolt and nut assemblies

2 “Design” and change of the overall thickness of the border of the eye

7 Summary data for the welding of cast irons

BS EN 148-1 on standard thread connection for facepieces in respiratory protective devices is useful for:

volume or energy basis)

Molecular mass has been changed to molecular weight according to the IUPAC rule

BCC (ISO/IEC 3309