UCPL210-50MM L3 50mm Standard Duty Low Shaft Set Screw Locking Pillow Block BearingClick here for spec sheet: UCPL Spec Sheet

Ideal for washdown environments & is USDA approved

Pilot bore can be opened to the nominal ID reflected in the part number

Design fully engages the shaft without marring

Provides greater axial holding power than set screw or one-piece clamping collars

Heavy guage two-piece housing has rust proof plated finish

Double-taper

Ideal for space constrained areas

Can be mounted vertically or horizontally

Climax Series C801 Single Nut Locking Assemblies deliver a mechanical interference fit and provides a higher torque capacity over alternative keyed connections

Allows you room to re-bore the ID without damaging the clamp screws

Acetal Copolymer collars will not rust or corrode

Housing is crimped together at bolt holes