Undercuts and runouts for screw threads - Specification for ISO metric screw threads1 Scope This Part of BS 1936 specifies requirements for dimensions for form, width and diameter of undercuts and runouts for ISO metric external and internal threads for use in general engineering applications. Threads may be cut or rolled without the die or tap fouling the component. Recommendations for undercuts and runouts for high duty applications are given in Appendix A. NOTE The titles of the publications referred to in this standard are listed

5) included in the Minimum set of data (3

This Eurocode applies to the design of buildings and civil engineering works in timber (solid timber

stable and structurally sound

Rounding-off procedure

data status category

The use of an analyser to determine CO and CO2 in combustion products from the following types of gas fired appliances:- Flueless appliances (type A appliances)

with a base upstream gravimetric level of 10 mg/L

Television and frequency modulation radio signal level

which may be used for identification of environmental aspects during welding fabrication of metallic materials including site and repair work

BS EN ISO 6682 is a guide for the design of the operator compartment controls for earth-moving machinery

Emergency stop controls

It serves as a reference document in the specific standards for appliances that fall within the scope of the Council Directive on the approximation of the laws of Member States concerning gas appliances 2009/142/EC