End mill holder Weldon with cooling channels HSK 63 - 20 - 100Application: For mounting straight shank tools with lateral flat according to DIN 1835 form B (Weldon). Delivery: With clamping screw and O ring All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m Tensile strength in the core of min. 800 N mm after DIN All functional surfaces fine machined

With clamping screws

Further information on the articles included can be found under the respective article number

Retaining screw for mounting of face mills arbors

E3= 20 pieces

clamping depth = 41

Collets sealed for high pressure cooling 120 bar with IC DIN 6499 B (ISO 15488 B) ER-system

The caliper will be ready for measurements as soon as it is switched on with the LCD screen displaying the actual slider position

or fi xation on T-groove tables

Zero setting at any position

Reading parts dull chromed

Metric/Inch conversion at any position

prevents overfeeding